The Combination Gauge Guide

The combination gauge has 4 main parts, the wooden stem, the wooden stock, the setscrew and the marking pins. The stock has a lock system on it to allow it to keep the distance from the pin, this enables you to mark exactly the right location. The reason this is called a ‘combination gauge’ is because it combines the functionality of two very similar tools, the marking gauge and mortise gauge. The marking gauge has one pin and the mortise gauge has two. In a combination gauge the the single pin is one side of the stem and the double-pin mechanism is on the other side.

Uses

The combination gauge is used to mark parallel lines lightly on the surface of wood. The twin pin side can be used to mark out the width and position for a mortise and tenon joint. The single pin side is used to mark the depth for recesses or the width or thickness of a board when sawing or planing it to size. There are a wide variety of other marking functions that this tool is useful for. The combination gauge is very important in creating accurate joints. While you would rarely see the lines made by a gauge in a finished piece of furniture, they make accurate joinery much easier.

Terminology

Pins- These are the small metal spikes held in the stem of the gauge that mark the wood on contact

Stem- This is the long section of wood that houses the pins. It slides through the head to set the distance for marking

Stock- This locks into position on the stem and is used to butt up against the reference edge

Wear Plates- Metal plates on the surface of the wooden gauges

Setscrew- Locks the stock to the stem

Types of Gauges

The combination gauge is a mixture of 2 traditional gauge types:

  • The Marking Gauge (this has one pin for marking a single distance line parallel to an edge)
  • The Mortise Gauge (this has two pins used to layout two parallel lines at once. One of the pins is fixed in the stem while the second pin is adjustable)

Parts of the Combination Gauge

Stock

Stem

Pins

Pin Bar

Locking Screw

2 comments on “The Combination Gauge Guide

  1. I recently bought a combination gauge but am finding it difficult to keep the lines straight when I drag it .

    • Hi Nick,

      Thanks for your comment.

      Paul suggests practising applying the right pressures in the right direction. He says there is a tendency to want to press the gauge down into the wood when really we’re simply trailing the pins to mark the surface.

      I hope this helps!

      Kind Regards,
      Izzy

Privacy Notice
You must enter certain information to comment on this page. We take the handling of personal information seriously and appreciate your trust in us. Our Privacy Policy sets out important information about us and how we use and protect your personal data and it also explains your legal rights in respect of it. Please click here to read it before you comment.

Leave a Reply

Your email address will not be published. Required fields are marked *