Round Rod

For this, you will need:

 

 

1. Once you have cut your wood to a square section, you can use a coin to draw around on the ends.

  • P2077468
  • P2077472

 

An alternative method would be to use an appropriately sized brace bit to score the surface and mark the circumference. To do this, use a steel rule to make a mark from each corner to corner to find the centre position, use a square awl to create a lead in for the bit.

  • P2077473
  • P2077476
  • P2077478
  • P2077482
  • P2077488
  • P2077492

 

2. Use the steel rule to mark the corners at roughly 45° on the end section, follow these lines down the side.

  • P2077495
  • P2077497
  • P2077498

 

3. Use a long clamp to hold your wood in the vise horizontally. You can either use a plane with a heavy cut to remove the four corners or use a spokeshave. Take full length shavings as evenly as possible along the entire length.

  • P2077504
  • P2077516
  • P2077518
  • P2077523

 

4. Once all four corners have been removed your cross section will be an octagon, keep turning your wood in the vise and remove all the smaller corners.

  • P2077526
  • P2077527

 

5. Once you have taken off the corners and you’ve nearly reached a round surface, switch between a card scraper and abrasive paper to smooth the shape.

  • P2077530
  • P2077532
  • P2077535
  • P2077539
  • P2077553
  • P2077558

One comment on “Round Rod

  1. Thanks team. This refreshed and old mans memory and I have a use for it on a project I’m working on. I’ve used this before for a round tenon on a cane but didn’t think about using it to make a dowel.

    Thanks Harpld

Privacy Notice
You must enter certain information to comment on this page. We take the handling of personal information seriously and appreciate your trust in us. Our Privacy Policy sets out important information about us and how we use and protect your personal data and it also explains your legal rights in respect of it. Please click here to read it before you comment.

Leave a Reply